Nivelmap
EN

Wraxall water level

River gauge, Land Yeo, Somerset, United Kingdom

Directions

Right now

Far below the normal range

Water level

0.02m Steady over the last 24 hours

0.0 0.5 Highest onrecord 0.86 m Lowest on record 0.02 m

History

History
0.020.04mOct 15Oct 15Oct 16Oct 17Oct 18Bottom of normal range0.020.04mOct 15Oct 16Oct 18Bottom of normal range
Water level Top of normal rangeBottom of normal range

What this means

Low water at Wraxall: the gauge reads 0.02 m, far below normal.

The usual range here runs from 0.06 m to 0.60 m. The lowest reading on record is 0.02 m (August 11, 2022).

The level has held steady over the past 24 hours. Without real rain upstream, that is unlikely to change quickly.

Autumn rain usually starts to lift rivers again after the summer low.

Compared with the normal range the agency publishes for this gauge. How to read levels

Key numbers

Normal range
0.06 m – 0.60 m
Highest on record
0.86 mNovember 15, 2025
Lowest on record
0.02 mAugust 11, 2022

For anglers and canoeists

Low rivers are hard going for paddlers, with exposed gravel and weirs that are awkward to shoot. Salmon and sea trout usually wait for the next spate to run.

Many angling and canoe clubs check gauges like this one before heading out.

Weather at the gauge

Rain in the last 3 days: 2.5 mm. Rain that falls upstream can take hours or days to show up at a river gauge.

18 Sun 13° 5° – Wind 21 km/h
19 Mon 14° 8° 5.2 mm, 92% Wind 17 km/h
20 Tue 12° 7° 0.6 mm, 76% Wind 7 km/h
21 Wed 10° 6° 4.2 mm, 45% Wind 19 km/h
22 Thu 14° 7° 7.9 mm, 74% Wind 17 km/h
23 Fri 10° 7° 14 mm, 88% Wind 25 km/h
24 Sat 10° 6° 4.7 mm, 65% Wind 25 km/h

Forecast: Open-Meteo

Sunrise 07:40 AM Sunset 06:14 PM Daylight 10 hr, 33 min First quarter 52%

Map

Nearby gauges

Gauge Level Compared with normal 24 hours Distance
Markham BrookRiver gauge 5.30 m Very low ±0 6.1 km
Colliters BrookRiver gauge 0.01 m Low ±0 7.9 km
Ashton ValeRiver gauge, River Avon 0.94 m Normal +0.01 m 8.3 km
IwoodRiver gauge, Congresbury Yeo 0.05 m Low ±0 9.1 km
Bristol Bedminster St Johns Lane UpstreamRiver gauge, River Avon 0.33 m Normal ±0 10 km
Bristol Harbour Passage StreetRiver gauge, Bristol Frome 6.16 m Low ±0 11 km
Chew Magna LevelRiver gauge, Winford Brook 0.16 m Normal ±0 12 km
Chew StokeRiver gauge, Chew Stoke Brook 0.01 m Lowest on record ±0 12 km

Questions and answers

What is the typical range for the Land Yeo at Wraxall?

The Environment Agency gives a typical range of 0.06 m to 0.60 m for this gauge.

Is the river level the same as the depth of the water?

No. The reading is measured from a fixed zero mark at the gauge, so 0.02 m on the gauge does not mean the water is that deep.

What is the water level of Wraxall today?

On 18 Oct 2026, 20:00 BST, the water level was 0.02 m. Steady over the last 24 hours.

Is Wraxall rising or falling?

Steady over the last 24 hours.

Is the level of Wraxall normal?

Far below the normal range. Compared with the normal range the agency publishes for this gauge.

What is the highest water level ever recorded at Wraxall?

The highest level on record is 0.86 m on November 15, 2025. The lowest is 0.02 m on August 11, 2022.

How often is this data updated?

The Environment Agency publishes a new reading every 15 minutes. This page refreshes within minutes of each update.

For specialists

Station codes, datum, parameters, data quality and downloads
Operator
Environment Agency
Station code
ea:E7048 (Agency page)
Coordinates
51.44066, -2.74531 (WGS84)
Vertical datum
station datum
Update interval
every 15 minutes
Licence
Open Government Licence v3.0. Contains Environment Agency data licensed under the Open Government Licence v3.0

Published series

ParameterLast valueTime (UTC)Quality
Water level 0.02 m 2026-10-18 19:00 Provisional

Download

Embed this gauge

Add a live card for this gauge to your website. It updates on its own and links back here.

How to cite

Environment Agency: Wraxall (ea:E7048). Accessed October 18, 2026 via Nivelmap, https://nivelmap.com/en/united-kingdom/somerset/wraxall

How we check values

Each reading is stored as published. We hold back values that jump faster than physically plausible and show the measurement time with every value.